Repairing Membrane Roofs

The installer did not install new edge flashing that had the pvc material attached at the factory.

Repairing membrane roofs. The kind of primer recommended by the roofing manufacturer may be used after cleaning the membrane for superior adhesion. The only permanent repair is to install the proper edge flashing and weld a pvc sheet to it. Use a 3 inch paint roller to apply rubber to rubber contact cement to one half of the outlined repair area and to one half of the underside of the rubber patch. Apply a thin coat of epdm roofing primer to the membrane surface where the patch is to be applied using a paintbrush or a paint roller with a medium nap roller cover.

Clean the area thoroughly with rags. Wait about 10 minutes for the cement to dry. Prime the repair area. Make sure the primer extends beyond all edges of where the patch will go.

Take extra care to get the membrane clean and free of any soap scum or oiliness. Sweep the area free of dirt and debris using a push broom. Ensure that it extends 2 inches beyond. Lift off the patch and brush membrane cleaner over the outlined repair area on the roof and onto the underside of the rubber patch.

The torch down rubber membrane is still by far the best roofing membrane and will outlast any other roofing membrane. Apply a thick even coat of edpm primer to the area using a paintbrush. How to repair a torch down rubber membrane roof if you have a torch down rubber roof and it was protected against ultraviolet rays with a silver coating or a ceramic surface then it could last indefinitely. Hire a reliable roof repair company for your tpo membrane replacement repair and installation.

Make sure to roll patch in place so that adhesive grips the membrane. To get reliable tpo roofing in waxahachie tx schedule a meeting with refuge roofing and contracting to get service from the best roofing technicians in the area. Remove old caulking material with a scraper. If it is not possible seal with urethane.