Removing Window From Spitfire 1500 Door

I try to figure out why the driver s side door won t fit properly but then ignore that for a bit longer and move on to repair some cancer on the front of th.

Removing window from spitfire 1500 door. 36 years with the same top time to get ready for spring time rain storms. Waist seal removal and refitting refitting the rubber and furry seals that run along the top of the door. Remove the single screw that holds in door handle bezel by pulling on the handle with one hand and slipping the bezel off with the other hand fig. Door panels roll window all the way down then remove the window crank handle by using two screwdrivers one to pry the panel and handle apart and one to carefully push out the retaining clip fig.

The window crank is held on by a small pin the photo shows the pin being put back in upon reassembly. This page shows the specific location of each kind. Door clips placement there are two different door clips holding door panels on 1500 s. Door panel removal removal and installation of door panels.

Triumph spitfire door trim panels and aperture seals original trim specification availability the very first spitfire was launched in october 1962 and production continued for nearly 20 years when the very last spitfire 1500 rolled off the production line in august 1980. Removal of fittings the chrome fitting around the inside door handle is held on by a single screw. They are made with a beautiful chrome finish and are a great way to freshen up your car s appearance. Flathead screwdriver safety glasses and gloves.

Remove the single screw that holds in door handle bezel by pulling on the handle with one hand and slipping the bezel off. Note although the door handles are fitted with lock barrels and are supplied with keys it can not be guaranteed that the keys will match side to side. I picked up a robbins unit from. Remove the screw and snake the fitting off the handle.

Roll window all the way down then remove the window crank handle by using two screwdrivers one to pry the panel and handle apart and one to carefully push out the retaining clip fig.