Remove Xterra Rear Door Panel

Make sure you open the back door glass first.

Remove xterra rear door panel. After removing the covers unscrew the 10mm golden screws. Here are the instructions from the service manual. Use the end of the removal tool to carefully pry up on the bottom rear corner of the plastic door panel. 3 remove the arm rest.

Use your panel tool to pry up the arrest and remove one exposed phillips screw. How to remove a nissan xterra door panel. 2007 xterra door panel removal. You have only have to remove the screws on the door handle once you remove the handle just pull the panel.

Remove switches from panel trim by removing screws holding it to cover you will feed the switches through when you pull door panel remove trim under door latch by prying at seam. Then pry off the screw cover beneath the door pull and undo the single. From here all you need to do is pry off the door panel from the door. Pry the trim off the door release cup with your panel tool.

I was able to install the new deck without issue and it works great. Remove first aid kit there are 2 screws behind it the other two are holding the grab handle on. The panel is help by plastic clips all around the door spaces roughly 9 around. Open the rear door as wide as it will go.

This will prevent the battery from discharging during the procedure. Instructions 1 turn the interior courtesy light off. Slide the tool under the edge of the panel to locate the first plastic clip. The door opening handle trim is held in by either a screw behind a plastic flap that will pop out behind the lever or it is held in at four points by plastic tabs two on top and two on the bottom that can be undone carefully with a screwdriver or the like.

There is a front and back piece under the latch. Start at the bottom and work your way around and up. I know this is a simple question but i am new and wanted to start learning about customizing my 2007 xterra xe used but new for me i thought a good first step would be upgrading the cd deck and speakers. A first use a plastic trim tool to lift the rear of the arm rest and lift enough to make a small gap as shown in.

Press the tool against the clip until the clip is in the center of the tool and snapped into the wedge cut into the tool. Pry up the panel. After you remove the 4 screws gently pull the panel directly away from the hatch it will snap off.