Remove Old Yale Bathroom Door Lock

Tug on the knob and it will slide right off.

Remove old yale bathroom door lock. How to removed yale knob lock from the door duration. Find all posts by xsleeper. Push the tip of a narrow blade screwdriver or nailset into the hole. Then the rose will slip off and you can take the screws out.

32 old yale mortise cylinder with good keyway duration. If the rose doesn t come off with the knob you ll need to remove it separately. In just three quick steps you can remove an existing cylinder lock for re keying or replacement. The way around this is to basically bash the paint off until you find a screw head and can actually unscrew it without stripping the head.

Once triggered the lever or lock trim can be removed from the door. Shop the home depot for door knobs interior doors and more. Look for a slot on the inside doorknob cover plate where you can insert a small flathead screwdriver. Remove hardware from the door or frame both the rim lock and hinges had been painted many times over the years meaning the screw heads were invisible and they had basically been glued to the door and frame.

Start by using your phillips head screwdriver to remove any visible screws from the interior side of the door. Wedge a pin or the tip of your flathead screwdriver under the small opening between the rose and the surface of the door. Screw heads may be of the slotted. Inspect the lever and faceplate on both sides of the door and locate the single mounting screw on the lever shaft and two or more screws on the faceplate.

Remove the screw with a phillips head screwdriver or allen wrench depending upon the screw head. This is showing how you can get your lock apart when you don t see any screws. This was a keyed door lever lock but i mention how to do the same with the sta. Gently pry it off or pull and twist it away from the door.

If any screws are exposed during this process remove them to release the lock and remove it from the door. These are the screws that hold the lock and the door together. The next video is starting stop. Some covers will have a set screw on the thin edge of the cover.

Apply a bit of pressure to the paper clip to trigger a release button inside the hardware. Insert the screwdriver into the slot and pry the cover off the assembly.